Skip to main content
Version: 0.52

Application Mempool

Synopsis

This sections describes how the app-side mempool can be used and replaced.

Since v0.47 the application has its own mempool to allow much more granular block building than previous versions. This change was enabled by ABCI 1.0. Notably it introduces the PrepareProposal and ProcessProposal steps of ABCI++. For more information please see here

Pre-requisite Readings

Mempool​

  • Before we delve into PrepareProposal and ProcessProposal, let's first walk through the mempool concepts.

There are countless designs that an application developer can write for a mempool, the SDK opted to provide only simple mempool implementations. Namely, the SDK provides the following mempools:

The default SDK is a No-op Mempool, but it can be replaced by the application developer in app.go:

nonceMempool := mempool.NewSenderNonceMempool()
mempoolOpt   := baseapp.SetMempool(nonceMempool)
baseAppOptions = append(baseAppOptions, mempoolOpt)

No-op Mempool​

A no-op mempool is a mempool where transactions are completely discarded and ignored when BaseApp interacts with the mempool. When this mempool is used, it is assumed that an application will rely on CometBFT's transaction ordering defined in RequestPrepareProposal, which is FIFO-ordered by default.

Note: If a NoOp mempool is used, PrepareProposal and ProcessProposal both should be aware of this as PrepareProposal could include transactions that could fail verification in ProcessProposal.

Sender Nonce Mempool​

The nonce mempool is a mempool that keeps transactions from an sorted by nonce in order to avoid the issues with nonces. It works by storing the transaction in a list sorted by the transaction nonce. When the proposer asks for transactions to be included in a block it randomly selects a sender and gets the first transaction in the list. It repeats this until the mempool is empty or the block is full.

It is configurable with the following parameters:

MaxTxs​

It is an integer value that sets the mempool in one of three modes, bounded, unbounded, or disabled.

  • negative: Disabled, mempool does not insert new transaction and return early.
  • zero: Unbounded mempool has no transaction limit and will never fail with ErrMempoolTxMaxCapacity.
  • positive: Bounded, it fails with ErrMempoolTxMaxCapacity when maxTx value is the same as CountTx()

Seed​

Set the seed for the random number generator used to select transactions from the mempool.

Priority Nonce Mempool​

The priority nonce mempool is a mempool implementation that stores txs in a partially ordered set by 2 dimensions:

  • priority
  • sender-nonce (sequence number)

Internally it uses one priority ordered skip list and one skip list per sender ordered by sender-nonce (sequence number). When there are multiple txs from the same sender, they are not always comparable by priority to other sender txs and must be partially ordered by both sender-nonce and priority.

It is configurable with the following parameters:

MaxTxs​

It is an integer value that sets the mempool in one of three modes, bounded, unbounded, or disabled.

  • negative: Disabled, mempool does not insert new transaction and return early.
  • zero: Unbounded mempool has no transaction limit and will never fail with ErrMempoolTxMaxCapacity.
  • positive: Bounded, it fails with ErrMempoolTxMaxCapacity when maxTx value is the same as CountTx()

Callback​

The priority nonce mempool provides mempool options allowing the application sets callback(s).

  • OnRead: Set a callback to be called when a transaction is read from the mempool.
  • TxReplacement: Sets a callback to be called when duplicated transaction nonce detected during mempool insert. Application can define a transaction replacement rule based on tx priority or certain transaction fields.

More information on the SDK mempool implementation can be found in the godocs.